GRIPPS V-Gripp Tape and Tool Catch Kit

The GRIPPS® V-Gripp Tape and Tool Catch Kit adds load-rated connection points to your tools without adhesives: fit a tool catch, then wrap it with self-vulcanizing V-Gripp Tape, which bonds to itself on contact. The kit is made to ANSI/ISEA 121-2018.

V-Gripp Tape and Tool Catch Kit at a glance

• Contents6 tool catches in two sizes, 1 roll of V-Gripp Tape
• TapeSelf-vulcanizing, no chemical adhesives
• Heat resistanceTo 302°F (150°C)
• ResistsWater and oil

How it fits into a tethering system

The tool catch is the connector end of the system: once it is taped to the tool, a tool tether clips to its ring. V-Gripp Tape also works with the GRIPPS Tool Hitch range.

Fitting a tool catch

Cut about 12 in (30 cm) of V-Gripp Tape, or enough to go around the tool 10 times. Position the tool catch on the tool, then apply the tape pulled tight, without covering the catch's ring.

What's in the kit

• 3 × Tool Catch, 0.5 x 2.25 in (12 x 55 mm) (H01005)
• 3 × Tool Catch, 1 x 3.5 in (25 x 90 mm) (H01006)
• 1 × V-Gripp Tape (H01010)